the machine still runs yea
<JT-Shop> yea it still runs
<rob_h> what id do now is take some voltage and current readings
<rob_h> ull knew where u are with current drive output, a replacement will be adoddle then 
<rob_h> use meter to measure U - V say, and a clamp to get currents
<JT-Shop> take the readings on UVW at the motor
<rob_h> go from say 100rpm, 500, 1000, 1500,go up in 500s then
<rob_h> u want from say U accross V so get phase reading
<JT-Shop> a bit better one http://imagebin.org/284914
<rob_h> account two phases in effect
<rob_h> accross
<rob_h> like ud check a 3phase power for balance
<rob_h> id not worry about measure each phase voltage as be pritty even... just give us a idea of what the voltage to hz ratio is
<rob_h> and current draws